The installation of AutoSonic is really easy. Nevertheless if you feel more comfortable contacting an expert installer, you can find the installer available in your area, click on the link below.
To see the Installation Video, you need the QuickTime installed in your computer. Download QuickTime
Beginning with the installation, first locate where you are going to install the sensors and place a piece of masking tape.
Measure and mark the positions of the holes.
Drilling position must be perpendicular to the surface of the bumper.
As you push, wiggle the sensor and make sure it goes all the way in and flush against the bumper, leaving no gap.
Wiring Installation
Route the cable through vehicle panels (option A or B.)
What does kit contain?
•
•
•
•
•
•
4 “in-bumper” type sensors with attached cable.
Waterproof Main System Control Box.
Color Display With Self-Adhesive on the bottom of the base.
Display Cable.
7/8" (22mm) drill bit: Precise bit to drill the exact holes for the sensors.
User's Manual and Installation Instruction.
How to test
•
•
•
•
Apply the parking brakes.
Turn ignition on. (Do not start the vehicle.)
Place the shift gear to reverse position.
From behind the vehicle proceed to check the system by placing the palm of your hand slowly back and forth in front of each sensor. Note: make sure you check all of them.
